Message #5594

[jim-ratliff]

Skis should already have the rail mounted on to the ski?  Then all you do is clip the bindings to the carrier bar and slide the carrier onto the rail.  No tools required except a dime ( or a flat head scredriver) to tighten the center screw.

DIN rules haven't changed, even since YOU were a kid, so whatever your old bindings were set to would be OK.  Actually, flex systems like this can get by with a lower DIN setting because the forward pressure doesn't increase and decrease as the ski flexes.  I'm 5'11", age 59, 195 pounds and a level 6 skier and never have pre-release problems with a DIN of 6.5  (boot sole length is 315 which is the other factor in DIN values).

Ok, since you have removed the threat of lemon and salt, feel free to ask questions after you read the manual.